Compuprint 10200 Programmer Manual - Manual (Page 27)

Commands
23
ESC O
Disables the skipover perforation.
ASCII Code ESC 0
Hexadecimal Value 1B 4F
Decimal Value 27 79
This sequence sets the number of lines of the skipover perforation to the value 0 and so any skip
perforation set by ESC N is cancelled.
ESC Q
Sets the right margin. (EPSON)
ASCII Code ESC Q n
Hexadecimal Value 1B 51 n
Decimal Value 27 81 n
Range 1 < n < 225
This code sets the line length at the current horizontal spacing. It must be sent at the beginning
of the line.
The n parameter specifies the number of columns and for each type of horizontal spacing there is
a range of values, as shown in the following table: