Compuprint 10200 Programmer Manual - Manual (Page 214)

Interfaces
210
Signal Name Pin N° Source Description
SELECT 13 PRINTER When high, this signal indicates that the printer is on-line. It is put to
low state in case of initialization or test and program mode. In IBM
Proprinter emulation in low condition this signal signals a off-line
request from the operator panel, paper jam, paper end or paper size
errors.
AUTOFEEDX
T 14 HOST Active low level signal. Indicates whether a LF is performed after a CR
or not.
GND 16 - Logical ground level (0V).
CHASSIS
GND 17 - Frame ground.
+ 5 VDC 18 PRINTER Is the DC voltage supplied by a component that limits the driven
capability up to 100 mA.
SIGNAL GND 19-30 - Signal ground.
INIT 31 HOST Active low level signal. Indicates, that the printer is initializing. The
BUSY signal is forced high.
ERROR 32 PRINTER When low, this signal indicates that the printer is off-line, there is an off-
line request from the operator panel, or the printer is in an error state
because of: paper jam, paper end or paper size error, engine error,
output bin full or cover open condition.
+5V 35 PRINTER Pulled up to signal.
SELECTIN 36 HOST Active low level signal. Enables the printer.