Compuprint 10200 Programmer Manual - Manual (Page 67)

Commands
63
ESC =
Defines downloaded characters. (IBM)
ASCII Code ESC = n m id p t
Hexadecimal Value 1B 3D n m id p t
Decimal Value 27 61 n m id p t
This sequence allows you to design and then down-line load special characters not present in the
character set in use. Whenever you would like to start the DLL setting procedure, proceed as
follows:
•
Copy the character generator in ROM into RAM
•
Select the DLL generator
There are 256 entries of 9 bytes that compose the look up table of a character generator. One
entry describes one character as follows:
Byte 1, 2 The absolute address of the character definition.
Byte 3 :
- Bit 7 1: indicates that the character is a graphic character (connects at 6 lpi)
0: indicates that the character is an alphanumerical character
- Bit 6 0: indicates a DLL character
1: indicates a resident character
- Bit 5 to 0 These 6 bits indicate the effective number of dot columns of the character shape
stored in memory.