Artesyn MITX-CORE-820 Installation and Use (July 2014) - Manual (Page 99)

BIOS
MITX-CORE-820 Installation and Use (6806800M10H) 99
5.7 Accessing the MEBX Setup Menu
The following procedure allows you to access the MEBX setup menu:
1. During BIOS POST, press the hotkey F4.
2. Disable the Intel AMT hotkey function in the BIOS setup. Select "Advanced", choose "Intel
AMT configuration" then select "Intel AMT hotkey".
3. Enable the Intel AMT setup prompt that is located on the same page. Save and exit. During
the BIOS POST, press CTRL+P.
5.8 BIOS Update
The following procedure allows you to update the BIOS:
1. Prepare a dos bootable USB thumb drive.
2. Get the BIOS flash tool Pflash.exe from the BIOS vendor.
3. Copy the Pflash.exe and BIOS ROM file into the USB thumb drive.
4. Power on the MITX-CORE-820 board.
5. Press to enter the BIOS setup menu.
6. Select the USB thumb drive as the first boot device.
7. Save and reset, then the enclosure will boot from the USB thumb drive.
8. Run the command Pflash BIOS.ROM /bbl /cvar /sa to flash the BIOS.
0xED POSTCODE_EC_IPL_DXE
0xEE POSTCODE_EC_IPL_PPI
0xEF POSTCODE_EC_DXE_ARCH
Table 5-33 Architectural Status Codes (continued)
Status Code Code Symbol