Artesyn MITX-CORE-820 Installation and Use (July 2014) - Manual (Page 45)

Hardware Preparation and Installation
MITX-CORE-820 Installation and Use (6806800M10H) 45
Removing Memory Module
1. Wear the ESD-preventive wrist strap.
2. Release the module from the slot by pushing the spring latches on either side of the module
outward.
3. Lift the module from the motherboard.
2.5 Processor Cooler Installation
Installing the Processor Cooler
1. Wear the ESD-preventive wrist strap.
2. Take the processor cooler and the backplate out of the anti-static package.
3. Prepare the backplate by taking off the protective film to reveal the glue layer.
4. Align the backplate to the motherboard. The screw holes on backplate should fit exactly
over the holes on the motherboard. Make sure the glue layer of the backplate does not
touch any other part of the motherboard.
5. Place the cooler on the backplate and secure it with the provided screws.
6. Plug the fan header into the fan connector on the motherboard.
Damage of the Product and Additional Devices and Modules
 Incorrect installation or removal of additional devices or modules damages the product
or the additional devices or modules.
 Before installing or removing additional devices or modules, read the respective
documentation and use appropriate tools.