Artesyn MITX-CORE-820 Installation and Use (July 2014) - Manual (Page 43)

Hardware Preparation and Installation
MITX-CORE-820 Installation and Use (6806800M10H) 43
There are available spare parts of the components to be installed or replaced in the
equipment warehouse. When the available spare parts are lacking, contact Artesyn
Embedded Technologies for help in time. For details on how to get help from Artesyn
Embedded Technologies, visit
http://www.artesyn.com/computing/
Make sure that the new components are in good condition, without defects such as
oxidation, chemical corrosion, missing components, or transportation damage. Read this
document to familiarize yourself with the proper installtion and replacement procedures
of the component, as well as to master the skills required by the operation.
 Check the environment
Make sure that the power supply, temperature, and humidity meet the operating
requirements for the board and its components. For details, refer to the respective system
documentation.
 Prepare the parts and the tools
Prepare the components to be installed or replaced. When you hold or transport the
components, use the special antistatic package. Prepare the cross screwdriver, screws,
plastic supports, cooling gel, and ESD-preventive wrist strap.
 Confirm installation or changing position
Confirm the position where MITX-CORE-820 will be installed.
 If a serious problem occurs and cannot be solved when you install or replace the
component, contact Artesyn Embedded Technologies for technical support.