Artesyn MITX-CORE-820 Installation and Use (July 2014) - Manual (Page 57)

Functional Description
MITX-CORE-820 Installation and Use (6806800M10H) 57
The design implements a separate LVDS and Backlight Inverter connectors located on the
board. The connectors follow the common parts used on Artesyn products.
A jumper on the board is used to select power supply for LVDS monitor. +3.3 V is the default,
while +5 V or +12 V are other options. +12 V and +5 V can be used to power the inverter, with
+12 V as default.
4.6.2 VGA
The design implements a VGA connector on the board edge.
Table 4-3 LVDS Panel VDD Selector (P29)
Jumper setting
(Jumper:P29)
Configuration
P29 (2-4) +3.3 V (Default)
P29 (3-4) +12 V
P29 (6-4) +5 V
Table 4-4 LVDS Inverter Connector (P8)
Pin Signal
1 +V12S
2 L_BKLT_EN
3 GND
4 L_BKLT_CTRL
5 +V5S
Figure 4-3 LVDS Inverter Connector (P8)