Artesyn ATCA-MF106 Installation and Use (September 2014) - Manual (Page 59)

Board Exchange
ATCA-MF106 Installation and Use (6806800M62B) 59
2. Check for damage and report any damage or differences to the customer service.
3. Remove the desiccant bag delivered together with the board and dispose of it
according to your country’s legislation.
4.3 Installing the Board
Before starting to install the board, observe the following:
Since the backplane has no possibility to store the information on the shelf (part number, serial
number, etc.), this information is stored in the boards themselves. The software on the board
always updates this information on a newly inserted board.
The board is thoroughly inspected before shipment. If any damage occurred during
transportation or any items are missing, please contact our customer's service immediately.
Board Damage
Touching the board or electronic components in a non-ESD protected environment causes
component and board damage.
Before touching boards or electronic components, make sure that you are working in an
ESD-safe environment or wear ESD wrist straps.
 Never exchange more than one of these FRUs (boards) at the same time to guarantee
that the shelf information stays consistent and up to date.
 The board must only be operated in a shelf that is properly grounded.