Artesyn ATCA-MF106 Installation and Use (September 2014) - Manual (Page 53)

Controls, Indicators and Connectors
ATCA-MF106 Installation and Use (6806800M62B) 53
3.3 Sensors
The IPMC functionality is based on the IPMI specification V1.5.
The IPMI sensors on the ATCA-MF106 are shown in the table below. For further information,
see the ATCA-MF106: Control via IPMI Programmer’s Reference.
TXD 3
Ground 4
Ground 5
RXD 6
nc 7
CTS 8
Table 3-2 COM 0 Front Panel Serial Port Pin-out Listing (continued)
SIGNAL PIN
Table 3-3 ATCA-MF106 Specific Sensors
Sensor Name
Type of
Measurement
What Does It Measure?
Sensor/
Reading Type
Class
Availability
MF106 IPMC OEM 0xD5 Major IPMC events Discrete Always
Boot Bank OEM 0xD2 U-boot sets to indicate
the currently active boot
bank Discrete Always after
payload has
first been
powered ON
Active Boot OEM 0xD2 The selected boot bank
during BT interface
initialization Discrete Always after
payload has
first been
powered ON
MF106 FPGA
Version OEM 0xD6 Revision of FPGA
firmware Discrete Always after
payload has
first been
powered ON
FW Revision ISC OEM 0xD6 Revision of ISC firmware Discrete Always