Artesyn ATCA-MF106 Installation and Use (September 2014) - Manual (Page 51)

Chapter 3
ATCA-MF106 Installation and Use (6806800M62B) 51
Controls, Indicators and Connectors
3.1 Face Plate
The following figure highlights the position of LEDs and connectors on the face plate of the
board. They are described in sections
LEDs on page 51 and Ethernet Connectors on page 52 and
Console Connector .
3.1.1 LEDs
The following LEDs can be found on the face plate of the board. OOS, OK and ACT are ATCA
LEDs and can be controlled via IPMI. For more information, see the ATCA-MF106: Control via IPMI
Programmer’s Reference manual.
Figure 3-1 Face Plate
Table 3-1 Face Plate LEDs
LED Color Description
OOS (failure) Red Red: The ATCA-MF106 is out-of-service.
Off: The ATCA-MF106 is working properly.
IS (In Service) Green Green: The ATCA-MF106 is operating properly.
Off: Otherwise
Blinking: The board boots up.
ACT (active) Amber Amber: The ATCA-MF106 is active.
Off: The ATCA-MF106 is in the standby mode.
H/S Blue Blue: The ATCA-MF106 is ready to be extracted.
Off: The ATCA-MF106 is not ready to be extracted. Do not
remove the board during this state.