Artesyn ATCA-MF106 Installation and Use (September 2014) - Manual (Page 54)

Controls, Indicators and Connectors
ATCA-MF106 Installation and Use (6806800M62B) 54
IPMB0 State IPMB 0xF1 Status of IPMB0 Bus Discrete Always
Ejector State Button Switch
0x14 Ejector Handle State Discrete Always
MF106 Watchdog Watchdog
20x23 IPMI timeout
(watchdog) status Discrete Always
SYS FW PROGRESS System
Firmware
Progress 0x0F U-Boot boot progress Discrete While payload
powered ON
Boot Error Boot Error 0x1E Boot Error Cause Discrete While payload
powered ON
OS Boot OS Boot 0x1F OS boot information Discrete After OS boot
has completed
3.3V Overcurrent Current 0x03 Indicates if the current
limit of 3.3 V power
supplied to the
backplane has been
exceeded Discrete Always
Filter Presence Entity Presence
0x25 Shelf air filter presence Discrete Always
System Boot System Boot
0x1D Indicates system boot
origination Discrete Always
MF106 Temp Temperature
0x01 MF106 local board
temperature Analog Always
MF106 Hotswap Hotswap 0xF0 MF106 Hot Swap Status Discrete Always
Table 3-3 ATCA-MF106 Specific Sensors (continued)
Sensor Name
Type of
Measurement
What Does It Measure?
Sensor/
Reading Type
Class
Availability