AMETEK BPS Series - Manual (Page 93)

User Manual AMETEK Programmable Power
BPS Series 93
5.3 Output Programming
5.3.1 Set the Output
Output parameters are all set from the PROGRAM screen.
1. Use the MENU key and select the PROGRAM entry.
2. Press the ENTER key to bring up the PROGRAM menu.
or
2. Use the PROG key to directly bring up the PROGRAM menu.
There are two methods for programming output parameters:
IMMEDIATE mode
SET mode
5.3.2 Slewing Output Values with the Knob in IMMEDIATE Mode
The default mode of operation is an immediate mode in which changes to output parameters made with
the knob or the entry keypad are immediately reflected at the output.
To change the output voltage:
Counter
Clock
wise Clock
wise
INCR DECR
1. Place the cursor on the VOLTAGE entry
2. Rotate the knob clockwise to increase the value, counterclockwise to decrease the value
These changes take effect immediately.
To change the output frequency:
Counter
Clock
wise Clock
wise
INCR DECR
1. Place the cursor on the FREQ entry
2. Rotate the knob clockwise to increase the value, counterclockwise to decrease the value
These changes take effect immediately.
5.3.3 Change Output Values with the Knob in SET Mode
The SET mode of operation is a mode in which changes to output parameters made with the knob or the
entry keypad do not affect the output until the ENTER key is pressed. The AC source is put in this SET
mode by pressing the SET key.