AMETEK BPS Series - Manual (Page 35)

AMETEK Programmable Power
BPS Series User Manual M440077-01 Rev A 35
4. Unpacking and Installation – BPS75 / BPS90 / BPS150 and BPS180
Models.
CAUTION: There are two basic models of the BPS Series power source hardware with different
hookup instructions. Verify that the model being installed is one of the models indicated above.
See section 3.0 for BPS30 and BPS45 versions.
4.1 Unpacking
Inspect the unit for any possible shipping damage immediately upon receipt. If damage is evident, notify
the carrier. DO NOT return an instrument to the factory without prior approval. Do not destroy the
packing container until the unit has been inspected for damage in shipment. If possible, retain the
container (wooden crate) in the event the system ever has to be returned to the factory for either repair or
upgrades
WARNING: This version BPS power source weighs approximately 2150 lbs /
975 Kg approximately
2475 lbs / 1123 Kg
). Obtain adequate help and proper equipment when
moving the unit. Make sure the location (floor) in which the BPS Series unit(s) will be installed
can support the weight of the unit(s).
4.2 Power Requirements
The BPS Series power Source has been designed to operate from a three-phase, three wire (Wye or Delta)
AC input line. A protective earth connection is required as well. (PE).
Available three-phase input settings are 208 V
LL
(option -208), 230 V
LL
(option -230), 400 V
LL
(option -
400), or 480 V
LL
(option -480).
CAUTION: Do not connect 400 or 480V into a unit set for 208 or 230V unit, the result could be a
severely damaged unit. Always check the input rating on the model number tag before connecting
AC input power. Consult factory if input settings have to be changed.