AMETEK BPS Series - Manual (Page 88)

User Manual AMETEK Programmable Power
BPS Series 88
WAVE GROUP Sets the user defined waveform group that will be loaded at power on.
Available groups are 0, 1, 2 and 3. Each group can contain up to 50
user-defined waveforms. A waveform group can only be loaded at
power up. To change groups, you must change this field to the desired
new group and cycle the power to the AC source or issue a *RST
command over one bus.
CLOCK MODE Sets the clock source used at power up. Available settings are Stand
Alone (STAND), MASTER (-LKM clock and lock master), and AUX
(-LKS clock and lock auxiliary).
NO. OUTPUT This field is always set to THREE can cannot be changed. It reflects
the three phase output configuration of the BPS Sereis.
VOLT ALC Determines ALC mode at power on. The ALC mode adjusts the
output voltage based on internal voltage measurement system and
provides enhanced output regulation and accuracy. Available settings
are ON, OFF or REG.