Adtec digital DTA-3050 (version 6.02.14) Manual User Manual
Page 78

On the Conditional Access page, select the CA tab you want to set. Up to five different CA system parameter settings can be
stored on the unit, one per tab. These settings are saved on the device as a configuration file, but are not transferrable to
another DTA device. Set the parameters as follows:
Parameter
Setting
Enable
select XCrypt from the drop-down menu
Super CAS ID
enter the CAS ID (value supplied by XCrypt), plus four zeros (0000)
CAS System ID
enter the CAS ID (value supplied by XCrypt)
ECMG IP
enter the IP address of the XCrypt server
ECMG Port
set to match Host Port (the default is the setting provided by XCrypt )
ECMG Channel ID
enter 0001
ECMG Crypto Period
enter 10
ECMG Keep Alive
enter 5
EMMG Mode
select TCP from the pull-down menu
EMMG Port
set to match Host Port (the default is the setting provided by XCrypt )
EMMG Maximum Bandwidth
enter 100 (maximum bandwith of the DTA3050 )
EMMG PID
set to hex value (user-defined)
EMMG Channel ID
enter 0001
EMMG Keep Alive
enter 5
Private Data Length
enter value supplied by XCrypt
Private Data
enter value supplied by XCrypt
You must click
69
Operations