Adtec digital mediaHUB-HD Pro (version 03.07.19) Quick Start - Manual

1920x1080 29i 33.77M
1DD 192K 2DD 192K 48
Front Panel Status
Video Resolution Frame Rate Video Bit Rate
Audio Input 1 & 2 Sampling Rate
media HUB-Pro
TM
Quick Start Guide media HUB Pro
High & Standard Definition MPEG2 Encoder
System LED Status
Power
Power is OFF
Power is ON
Alarm
No System Alarm
Minor Alarm
Major Alarm
Link
No Link Detected
Link Active
Busy
No Network Traffic
Network Traffic Present
HD
High Def. Encoding Disabled
High Def. Encoding Enabled
Adtec Digital Technical Support: 615.256.6619 www.adtecinc.com 06.09.2011
Encoder
Video
Encoder
Audio
Transmit PID Table Profile System
Login
Duration
Network
Time
NTP
Alarm
COM2
Firmware
Profile 1-10 Samp. Freq.
A1 A2
Sync
Input
Mode
Type
Bitrate
Volume
Front Panel Menus:
Use Mode Button to move through top layer menus.
Use arrows for navigation in submenus.
Use select to enter into edit mode and enter to save selection.
Encrypt.
Mode
Clear Word
Encrypt Word
User ID 1
UserID 2
Mux Rate
Vid. AutoFill
IP Destination 1-4
Units ship with the front panel
logged in by default. If you become
logged out and are prompted for a
password, use the following key
sequence for access.
Press when panel displays ‘User Login -- logged out’Press Press
‘User Login -- logged out’
Press
Press
Press
Press
Press
Table
VBI Source
Closed Cap.
Srv. Name
Srv. Provider
Status
Rate
Chroma
Input
GOP
GOP Str.
GOP Size
Hue
Bright.
Contr.
Satur.
PCR
Prog. No.
Map PID
Vid. PID
Aud.1 PID
Aud. 2 PID
TS ID
AMOL
Splice
VITC Mode
VITC PID
Getting Started
Thank you for your purchase of the Adtec mediaHUB Pro. This quick start
guide should help you with your initial setup. Further instructions are available via the
manual integrated into the on-board software. You can view it by looking for the HELP
tab once your unit is powered up and you are connected to the web-application. See
back for more details. This manual and the most recent firmware are available on our
support website, www.adtecinc.com. Advanced users can also find direct API
command help as part of the on-board web application.
Audio 1 & 2
Audio Not Enabled
Audio Enabled
Alarm
No Encoder Alarm
Encoder Alarm
Encode
Not Active
Pre-rolling (Studio Encode)
Encoding
Transition (Encoding to Idling)
Video
No Video (Audio Only)
Video Present
Format Not Supported
No Video Present
Resolution
Standard Definition ( NTSC / PAL)
1080i HD
720p HD
Front Panel LEDs: