Adtec digital RD-30 (version 2.1.1) Quick Start - Manual

Quick View Status
Quick Start Guide
Thank you for your purchase of the Adtec RD-30
4:2:0 Receiver/Decoder. The RD-30 is sold with
optional demodulator hardware and software
licenses. Please note that some configurations
may not be available in the front panel if the
licensed feature is not installed.
Adtec Digital US Sales +1-615-256-6619 International Sales +1-904-394-0389 www.adtecdigital.com 2014 Adtec Digital
MultiCODEC 4:2:0 Receiver / Decoder
RD-30
LED Status
Input
Off - Decoder does not have valid input
On - Decoder has valid input
Error / Alarm
Off - No errors detected
On - Active errors
Unit ID
Off - UID is disabled
On - UID configuration is enabled
The main status menu contains:
- Bitrate of incoming stream
- Current active Input
- IP Address of management port
- Current decoded service name
Unit Name
Bitrate: 19.400 Mbps
Input: MPEG/IP 2 Stream 1
IP: 192.168.10.48
Service: Adtec HDTV
Front Panel Navigation:
Use Back to move to
top level menus or
to cancel configura-
tion editing.
Use arrows for
navigation in
sub-menus and edit
mode.
Use the Enter
Button to enter
menus, enter edit
mode, and confirm
configuration
changes.
TS Outputs
ASI Output
IP Output
Active Errors
Error List
Inputs
Input Select
Switch to Backup
ASI Rx
IP Rx (MPEG/IP)
RF Rx (DVB-S2 1)
Conditional
Access
DVB-CI
BISS
Baseband
Outputs
SDI
Composite
Analog
Digital (AES)
Admin
Network
Mpeg/IP Network
Time
About
Voltage Levels
Unit Temp.
Profile
Lock Front Panel
Reset
UID
Decoding
Service Select
Video
Ancillary Status
Audio 1
Audio 2
Processing
Video
Audio
Genlock
Source ID
Genlock
ENTER
RD-30
MultiCODEC 420 Receiver / Decoder
RD - 30
Bitrate: 21.694 Mbps
Input: ASI
IP: 192.168.10.48
INPUT ERROR
BACK