Adtec digital DTA-3050 (version 6.02.14) Manual - Manual (Page 12)

Getting Started
Installation
The DTA-3050 can be installed and made operational in minutes.
First, the unit must be installed into a one-rack unit (1U) 19" rack slot, or any secure space where it cannot be easily
moved. 1.
Power should be applied to the unit and configured with a valid IP address, subnet mask, and default gateway via the
front panel via the LCD/Keypad for details on setting the IP parameters via the front panel refer to the procedures in
this section. 2.
Once the IP parameters have been configured, configuration may take place via the front panel or over the Local
Area Network via a Web browser. 3.
Select the output type: ASI (default) or SMTPE 310M.
If using IP only, please select ASI. ♦
When setting the unit up for ASI, a rate must be assigned to the output port before it should be connected to
a modulating device. ♦
4.
From a PC connected to a LAN, start a Web browser and in the URL box type the IP address configured.
Note, if no IP address has been configured, the default IP address can be used (192.168.10.48). ♦
5.
9 Getting Started