Adtec digital DPI-1200 (version 01.04.08U) Quick Start User Manual
Dpi-1200, Quick start guide, Digital ad server

Quick Start Guide
DPI-1200
Digital Ad Server
System
Splicer
Mode
Name
Splicer IPA
Splicer Name
Chassis
Card
Port
Lead In
Schedule ID
Format
Break Repeat
Multicast IPA
Multicast Port
Cue
<
<
DTMF History
DTMF Newest
DTMF Oldest
GPI State
GPI Time Changed
GPO State
DTMF Speaker
Login
Network
Time
NTP
Alarm
Mirror
RAID Status
Name
Firmware
NetSet
<
Mode
Days On
Type
Start
Stop
Pre-Roll
Post-Roll
Avail
End By
Front Panel Menus:
Use Mode Button to move
through top layer menus.
Use arrows for navigation
in submenus.
Use select to enter into edit
mode and enter to save
selection.
Reset:
Should you need to
reset your device, you
can do so via the front
panel by pressing the
MODE, ESCAPE and
RIGHT ARROW keys
simultaneously.
Units ship with the front panel logged in
by default. If you become logged out and
are prompted for a password, use the
following key sequence for access.
Press
‘User Login -- logged out’
Press
Press
Press
Press
Press
System LED Status
High Availability:
Each channel is individually configurable for
ASI or IP Streaming.
3 x Mirrored ASI ports allows for connection of
up-to 3 separate splicers.
IP streaming via Unicast or Multicast
using the GigE Connection.
*Note: If the same Multicast or Unicast address
for multiple channels, the Multicast Port will need to
be incremented by 2 for each channel.
Example: Channel 1 = Port 2000
Channel 2 = Port 2002
Thank you for your purchase of
the Adtec DPI-1200 Ad Server.
The most recent firmware
releases are available on our support
website, www.adtecdigital.com.
Advanced users can find direct API
command help as part of the on-board
web application, Help Tab.
Channels 1 - 12
Not Active
Channel Connected
Pre-Roll / Transitioning
Channel Disconnected
11.25.2013