beautypg.com

Communications, Rs-232, Ethernet – Adtec digital DTA-3050 (version 6.02.14) Manual User Manual

Page 24: Lan rs-232 ethernet

background image

Communications

LAN

The DTA-3050 incorporates two network ports for Ethernet communications over a Local Area Network (LAN) using the
Internet Protocol (IP). Command and control over a LAN can be accomplished using a Web browser using HTTP.

RS-232

The DTA-3050 provides an RS-232 interface for an experienced user for advanced troubleshooting. An RJ-45 connector
provides a console connection to the DTA-3050, so the unit may be connected directly to a PC’s communications port.

RS-232 Serial Default Parameters

Variable

Setting

Baud Rate

115,200

Data Bits

8

Stop Bit

1

Parity

none

Flow
Control

none; this is required if you are using Hyper Terminal or some other simple terminal application to
communicate with the DTA-3050 via command line.

Ethernet

The DTA-3050 provides an Ethernet (10/100BaseT IEEE 802.3u) interface to communicate with the unit over a Local Area
Network (LAN). Use of the Ethernet port supports connecting multiple units to a single PC through the use of an Ethernet
Concentrator (Hub). The only limitation is the number of ports on the hub and available IP addresses on the network.
Point-to-Point Ethernet connection can be achieved with an Ethernet crossover cable. The DTA-3050 also provides a Gigabit
Ethernet (10/100/1000) interface for IP Destinations. Both ports can provide web administration.

Caution: both interfaces must be on separate subnets. If both interfaces reside on the same IP network, there will be loss of
communication.

Ethernet Default Parameters

Variable

Setting

eth0 10/100

192.168.10.48

eth0 10/100 subnet mask

255.255.255.0

eth1 GigE IP address

192.168.20.48

eth1 GigE subnet mask

255.0.0.0

Gateway IP

0.0.0.0 (defaulted off)

User Name

adtec

Password

none

Getting Started

20