Redundancy screen – Adtec digital DTA-3050 (version 6.02.14) Manual User Manual
Page 59

Redundancy Screen
The Adtec DTA3050 can be used in conjunction with a second DTA3050 as a back-up. The unit designated as the back-up will
receive setting information from the Primary unit (the Primary unit essentially clones itself onto the back-up) and monitors the
Primary's input and output activity. Should the Primary unit suffer an output failure, the back-up immediately begins to stream
the same programming, providing greater service reliability for your customers.
Important: In order to use this feature, your DTA3050 must be running firmware version 6.03.02
Support to obtain this firmware.
The Redundancy Screen lists the following information:
Data
Function
Mux Redundancy Role
which role this unit is designated to perform
Mux Redundancy Other IP
the IP address of the other unit in a redundant pair
Encoder Switch
switch type
Screenshot:
Signed In
If the Redundancy screen is viewed while signed in, the table doesn't change in appearance, except for the presence of
pull-down menus for editing the settings:
Data
Control Type
Options
Mux Redundancy Role
pull-down menu
Disabled
Primary
Back-up
Mux Redundancy Other IP
text field
user-defined
Encoder Switch
pull-down menu
PESA LNS8
none
Screenshot:
51
User Interface