Altera QDRII SRAM Controller MegaCore Function - Manual (Page 46)

3–14 MegaCore Version 9.1 Altera Corporation
QDRII SRAM Controller MegaCore Function User Guide November 2009
Interfaces & Signals
Figure 3–10. Write—Burst of Four (Narrow Mode)
This section does not illustrate the burst of two example, because you can
transfer any data at any address in every Avalon clock cycle. The timing
of the qdrii_a signal is different, refer to
Figure 3–7 on page 3–11 .
Bursts with Pauses
There are no pauses when using a burst of two memories. For the burst of
four, there are some pauses (depending on the mode). In narrow mode, if
the transfers are to consecutive addresses all the time, no pause occurs. If
the transfers are to non-consecutive addresses, a pause may occur, refer
to
Figure 3–11 on page 3–15 . a pause occurs only in the following
conditions:
■ A one-cycle write to address followed straight away by a two-
cycle transfer to addresses and
■ The second half of the transfer to is paused for a clock cycle
avl_write
avl_data_wr[35:0]
avl_adr_wr[19:0]
avl_wait_request_wr
system_clk
qdrii_d[17:0]
qdrii_a[19:0]
qdrii_bwsn[1:0]
qdrii_wpsn
00010002 00030004 00030004
0002 0003
0001 0002 0003 0004 0004
0002
00 00
avl_clk
avl_clock_wr