2 dimensions, 3 install base unit without expansion module, 4 connecting the base unit and expansion modules – Pilz PNOZ m1p base unit User Manual
Page 15: Dimensions, Install base unit without expansion module, Connecting the base unit and expansion modules
Installation
Operating Manual PNOZ m1p (ETH)
20878-EN-12
15
Dimensions
94 (3.70")
121 (4.76")
135 (5.31")
Install base unit without expansion module
}
The terminator must be fitted to the side of the base unit marked “Termination/Link”.
}
Do not fit a terminator on the left hand side of the base unit.
Terminator
Termination/Link
Connecting the base unit and expansion modules
The modules are linked via jumpers.
There are 2 pin connectors on the rear of the base unit.
A max. of 12 expansion modules plus one fieldbus module may be connected to one base
unit.
}
Ensure that no terminator is connected.
}
Connect the base unit, the expansion modules and the fieldbus module using the jump-
ers supplied.
}
The terminator must be fitted to the last expansion module to the right of the base unit.
}
A terminator must not be fitted to the last expansion module to the left of the base unit.
5.2
5.3
5.4