Xblue Networks X-50 - Manual (Page 81)

XBLUE Networks 81
6 Programming Wizard
Getting Started
The X-50 is a fully functioning Voice over Internet Protocol (VoIP) Gateway and router, which is
programmed using a standard Internet browser such as Microsoft’s Internet Explorer
® . Any computer
with a Network Interface Card (NIC), connected to a TCP/IP network, can be used to program the X-
50 VoIP Telephone System.
Setup Wizard
Once the administrator logs in and authenticates the first time, the programming wizard will walk the
administrator through the programming process. The next time the administrator logs into the X-50,
after the programming wizard is completed, the administrator will be sent to the main programming
landing page which shows the current status of the X-50 VoIP Telephone System.
There are two ways to begin programming the X-50 system; manually or restore from a backup.
If restoring a backup, Click the next button and then locate the backup file and click on the Update
Settings button. The update will take about 2 minutes.
The system will reboot after uploading the configuraiton file.