StorCase Technology InfoStation 10-Bay 1U Ultra320/SATA User Manual

Page 68

InfoStation 10-Bay RAID User's Guide - Rev. E00

StorCase Technology, Inc.

RAID Controller Configuration

RAID Params Menu

1.1 Array 1

This function enables the user to configure/reconfigure Array 1.

1.1.1 Array 1 Reconfigure RAID

CAUTION:

Data lost during reconfiguration cannot be recovered! StorCase strongly
recommends the user to backup all data before reconfiguring.

NOTE:

To avoid accidental erasure of existing RAID configurations, Yes must be
selected prior to saving any new RAID configurations.

Select either No or Yes.

1.1.2 RAID Level

NOTE:

To remove an existing RAID level, reconfigure the array with RAID level None.

Select either 0, 1, 0+1, 3, 5, 30, 50, or None.

1.1.3 Disk Number

NOTES:

Verify that the required number of disks for all arrays are connected before
configuring an array. Refer to Table 3 for further information.

The number of disks in the array does not include the "hot spare" disk.

Select the number of disks in the RAID.

This manual is related to the following products: