Appendix c - troubleshooting – StorCase Technology InfoStation 10-Bay 1U Ultra320/SATA User Manual
Page 110

InfoStation 10-Bay RAID User's Guide - Rev. E00
StorCase Technology, Inc.
Appendix C - Troubleshooting
97
Appendix C - Troubleshooting
StorCase Technical Support
For assistance configuring and using this StorCase product, contact StorCase technical
support at (888) 435-5460.
Setup Problems
•
Unable to access the RAID Controller after OS boots up.
Cause - The RAID Controller might not be configured.
Fix -
Verify that the RAID Controller is configured for a RAID level. If no RAID level is
configured, the OS will not detect the RAID Controller as a disk.
•
Unable to recognize the disks.
Cause - There might be a disk drive jumper setting problem.
Fix -
Verify that all drive jumpers are set to "Master".
•
Unable to setup an array using Quick Setup.
Cause - Quick setup can only be used to set up new RAIDs. If the error message 'Array 1
Exists!' appears, an array has already been configured.
Fix -
Reconfigure the array from the RAID Params submenu.