Luxul XMS-1024P - Manual (Page 226)

226
XMS-1024P
a: 14203 Minuteman Drive, Suite 201, Draper, UT 84020-1685 | luxul.com | 801-822-5450
LUX-UG-XMS-1024P Vers: 081314
Choose the menu SNMP>>SNMP Confi g>>SNMP Group Settings to load the
following page.
Figure 13-5 SNMP Group Settings
The following entries are displayed on this screen:
Group Confi g
Group Name: Enter the SNMP Group Name. The Group Name, Security Model and
Security Level compose the identifi er of the SNMP Group. Groups with
these three items set the same are considered to be the same.
Security Model: Select the Security Model for the SNMP Group.
„
v1: SNMPv1 is defi ned for the Group. In this model the Community Name
is used for Authentication. SNMP v1 can be confi gured on the SNMP
Community Confi g page.
„
v2c: SNMPv2c is defi ned for the Group. In this model the Community
Name is used for Authentication. SNMP v2c can be confi gured on the
SNMP Community Confi g page.
„
v3: SNMPv3 is defi ned for the Group. In this model the USM mechanism is
used for Authentication. If SNMPv3 is enabled the Security Level
fi eld is enabled.
Security Level: Select the Security Level for the SNMP v3 Group.
„
noAuthNoPriv: No Authentication and No Privacy security level is used.
„
authNoPriv: Only the Authentication security level is used.
„
authPriv: Both the Authentication and the Privacy security levels are used.
Read View: Select the View to be the active Read View. Management Access is restricted
to Read-Only, changes cannot be made to the assigned SNMP View Confi g.