LINK Systems OmniLink II Press Automation Control - Manual (Page 81)

August 30, 2002 Manual Version 1.0 4.32
Note! The list of permissions shown on the screen is shown as an example. New software versions
and hardware modules developed to perform new functions may add to this list. Also, any action
that was chosen to be unrestricted in the screen of Figure 4.15 will appear in red in the
permissions list and such actions will not be restricted to Program Mode, regardless of whether
you select “Yes” or “No” under the used column for this item.
Section 4.2.4.3.5 Changing the User Configuration Code
Pressing the SET CONFIG. CODE softkey in the Access Configuration Menu, Figure 4.15, will display
the User Configuration Code screen, Figure 4.18. This screen allows the User Configuration Code to be
changed. This is the configuration code that protects against access to configuration screens by
untrained and/or unauthorized persons. It is imperative that this code be given only to authorized
personnel who are familiar with the control and with the consequences of incorrect parameter settings.
Figure 4.18 User Configuration Code Screen
The original configuration code is set at the factory. It is suggested that this code not be changed unless
the security of the configuration code has been jeopardized. If a configuration code has been obtained
by persons you do not wish to access the configuration parameters, it must be changed. When this code
is changed, the previous code will no longer be valid. The new code should be documented and
stored in a secure place.
If the current User Configuration Code is lost, the factory must be consulted to restore access to
configuration screens.
To change the configuration code, press the Change Number softkey, enter the new code, and press the
ENT key.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
SYSTEM STATUS
Counter OFF
8 0
Program/Run Switch
Config.
Code
CHANGE
NUMBER
EXIT
This Configuration Code is used to gain access to ALL
configuration screens associated with both standard and optional
features of the Automation Control. This code should only be
known to persons who have the technical knowledge and the
authorization of the employer to configure the Automation Control.
Caution! Certain configuration settings, such as Brake Monitor
limits, affect safety considerations. Others can affect whether elements
of the production system are properly controlled or monitored by
the OmniLink II Press Automation Control.
Make sure you record and keep this code in a secure place. If
it is lost, you will have to contact Link Systems to restore
access to the configuration screens.
Configuration Code :
Up to 4 digit configuration code appears here