LINK Systems OmniLink II Press Automation Control - Manual (Page 43)

August 30, 2002 Manual Version 1.0 3.10
Figure 3.7 Main Die Protection Screen in Run Mode for Module 1, Channels 1-8
Figure 3.8 Channel Settings Screen for Module 1, Channel 5
Once Program Mode is entered, the upper right softkey on screens throughout the OmniLink II
Press Automation Control is used in the editing (change) process of any setting selected by use of
the arrow keys on the operator terminal. See Sections 3.7 and 3.8.
In Key Only Access Mode,
the Channel Settings Softkey
will select the DP Channel
Settings screen so settings
can be viewed in Run Mode,
but the Program/Run switch
must be turned to Program
to change settings on the
DP Channel Settings screen. Stroke
Mode
Drive
Spe ed
Stroke
Spe ed
SPM
SPM
0
0
Order
Counter
SYSTEM STATUS
Counter OFF
Die
Protection
CHANNEL
SETTINGS
CHANNEL
DIAGS
NEXT
PAGE
0 0
OK TO P
EXIT
Ch Channel Type Description Status State
1 S tatic Stock Buckle OK Off
2 Not Used OK Off
3 1 Part Dete ctor Edge Par t Ou t OK Off
4 In Position Die Cam Retracted OK On
5 Cyclic Stripp er Left Front OK Off
6 Cyclic Stripp er Right Fron t OK Off
7 Cyclic Stripp er Left Rear OK Off
8 Cyclic Stripp er Right Rear OK Off
Module 1 - Channe l 5 Details
Input Type:
Stop Typ e:
Bypassed:
Delay Time:
Delay Strok es:
Window On:
Window Off:
Nor mally OFF
Top S top
No
0 msecs
0 S trokes
154
0
213 0
0
90 270
180
Channel
Status
OK
System Status: OK
Module Status: OK
SoftKeys
5
RESET
FAULT
Appears only with
Program/Run switch
in Program Position.
Stroke
Mode
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
SYSTEM STATUS
Counter OFF
DP Chan
Settings
CHANGE
SETTING
CHA NNEL
DIAGS
NEXT
CHA NNEL
0 0
OK T OP
EXIT
0
90 270
180
Die Prot. Channel Settings Module: 1 Channel: 5
Channel Type:
Description:
Input Type:
Stop Type:
Bypassed:
Delay Time:
Delay Strokes:
Window On:
Window Off:
C yclic
Left Fr ont Stripper
Normally OFF
Top Sto p
No
0 mse cs
0 Strokes
154 0
213 0
Help
Sets the type of Logic
to apply to the
channel
Cyclic - Norm. OFF
U sed to monitor events that occur
once per m achine cycle. The input
must be ON somewhere in the timing
window AND OFF somewhere in the
timing window.
PREVIOUS
CHA NNEL
DECREMENT
ON ANGLE IN CREM ENT
ON ANGLE DECREMENT
OFF ANGLE IN CREMENT
OFF ANGLE
SoftKeys
CHANGE SETTING,
CHANGE NAME, or
CHANGE NUMBER
in Program Mode
depending on setting
selected.