Hanna Instruments HI 9829 - Manual (Page 86)

86
The probe is suitable for measurements in a flow cell. Pumping water to a flow-
through monitoring station has obvious pros and cons. Typically a shelter is
required to secure a pump, and flow chamber. A power requirement, shelter,
pump maintenance and higher installation cost need to be considered. Freeze
protection, security, and convenience of calibration and possibility of adding
multiple measurement points and antifouling preconditioning systems are
advantages to this type of installation.
Hanna HI 7698297 Quick Release Flow Cell: Hanna HI 7698297 Quick Release Flow Cell: Hanna HI 7698297 Quick Release Flow Cell: Hanna HI 7698297 Quick Release Flow Cell: Hanna HI 7698297 Quick Release Flow Cell:
The HI 7698297 flow cell is shipped tested and ready for installation and
use. The following exploded view is provided to aid in reassembling and
inspecting after cleaning.
* Warning: Do not use organic solvents to clean flow cell.
When dissassembled for cleaning, inspect o-ring for nicks, cracks and
damage that may cause leakage. Replace o-rings as required and always
lubricate with grease provided in probe maintenance kit.