Denon AVR-4806CI - Manual (Page 85)

85
Advanced Operation
4. Monitor or TV system buttons
SRC ON : Power on
SRC OFF : Power off
SETUP : Setup
MENU : Menu
• , ª, 0 0 , 1 1 : Cursor up, down, left and right
ENTER : Enter
DISP : Guide
CH +, – : Switch channels +, –
0 ~ 9, +10 : Number
TV/VCR : Switch between TV and video player
When there are codes usable for the preset device,
those codes are sent when the buttons below are
pressed. If not, by default the DVD codes are punched
through. If the punch through setting is made after the
preset memory is set, the codes are sent with priority.
6 , 7 : Manual search (forward and reverse)
2 : Stop
1 : Play
8 , 9 : Auto search (cue)
3 : Pause
RC SETUP
IR segment
MODE SELECTOR
NUMBER
Learning function
• If an AV component is not a DENON product, or if it cannot
be operated via codes provided in the AVR-4806CI remote
control’s internal preset memory, or if its codes cannot be
successfully learned by the AVR-4806CI remote control, then
you should use the remote control that was supplied with
that AV component to operate the component.
1 Press and hold the RC SETUP button for at
least three seconds.
• The IR segment blinks twice.
2 Press the 9 , 7 , 5 button (9 → 7 → 5) to select
Learning setup.
• The IR segment blinks twice, indicating the remote
is in Learning set up mode.
3 Press the MODE SELECTOR button for the
component you want to learned.
Learning is not possible for the AMP, ZONE2, ZONE3,
ZONE4 and SYSTEM CALL modes.