Denon AVR-4806CI - Manual (Page 46)

46
Basic Operation
Press the ON SCREEN button.
Each time an operation is performed, a description of
that operation appears on the display connected to AVR-
4806CI’s VIDEO MONITOR OUT terminal. Also, the
unit’s operating status can be checked during playback.
Such information as the position of the input selector
and the surround settings is output in sequence.
Checking the currently playing program
source, etc.
¢ On screen display
Press the DIMMER button.
The display brightness changes in four steps (bright,
medium, dim and off).
¢ Using the dimmer function
• Use this to change the brightness of the display.
Press the STATUS button.
Descriptions of the unit’s operations are also displayed
on the front panel display. In addition, the display can be
switched to check the unit’s operating status while
playing a source.
¢ Front panel display
ANALOG INPUT MODE STATUS
DIMMER
ON SCREEN
SPEAKER
INPUT MODE
VIDEO SELECT
Switching the surround speakers
Press the SPEAKER button.
The surround speakers switch as shown below each
time the SPEAKER button is pressed.
SURROUND A
SURROUND A+B
SURROUND B
This operation is possible when the setting for using
both surround speakers A and B is made at “Speaker
Configuration” (
page 125, 126).
Press the VIDEO SELECT button until the desired
image appears.
Combining the currently playing sound
with the desired image (VIDEO SELECT)
• Cancelling simulcast playback:
Select the “SOURCE” pressing the VIDEO SELECT button.
• It is not possible to select HDMI and DVI-D input signals.
• When playing HDMI/DVI-D video input signals, the analog
video signal of another function cannot be selected for the
HDMI video output.
The video source selected with the video select function
is stored in the memory for the different input sources.
V I D E O S O U R C E
D V D