Denon AVR-4806CI - Manual (Page 44)

44
Basic Operation
Playing the input source
1 Select the input source to be played.
Example: CD
(Main unit) (Remote control unit)
To select the input source when ZONE2 SELECT,
ZONE3/REC SELECT or TUNING PRESET is selected,
press the SOURCE button on the main unit then operate
the input function selector.
SOURCE PHONES EXT.IN
ANALOG
ROOM EQ
HOME THX
CINEMA
INPUT
MODE VOLUME FUNCTION
VOLUME
INPUT MODE
HOME THX
CINEMA
ROOM EQ
MUTE
FUNCTION
2 Start playback on the selected component.
For operating instructions, refer to the component’s
manual.
3 Adjust the volume.
The volume can be adjusted within the range of –80 to
+18 dB, in steps of 0.5 dB. However, when the
channel level is set (
page 64, 65 or 128 ~ 130), if
the volume for any channel is set at +0.5 dB or greater,
the volume cannot be adjusted up to 18 dB. (In this
case the maximum volume adjustment range is “18 dB
— (Maximum value of channel level)”.)
Also, you may not be able to adjust the volume to the
maximum of 18 dB when internal volume
compensation control is activated due to the
combination of the surround mode and parameters,
downmixing from multi-channel audio signals into two
channels, etc.
(Main unit) (Remote control unit)
M.VOL. -80.0dB
The volume level is displayed on the master volume
level display.
¢ To choose the surround sound mode
Example: HOME THX CINEMA
Press the HOME THX CINEMA button.
For more information about the surround modes (
page 50 ~ 53).
¢ To select the Room EQ function
Press the ROOM EQ button.
For more information about the Room EQ function
(
page 48).