Denon AVR-4806CI User Manual

Page 82

Advanced Operation

Preset memory

Press the

MODE SELECTOR

button for the

component you want to preset.

Presetting is not possible for the AMP, ZONE2,
ZONE3, ZONE4, TUNER and SYSTEM CALL modes.

Press and hold the

RC SETUP

button for at

least three seconds.

• The top IR segment blinks twice.

Referring to the included List of Preset Codes
(

End of this manual), press the

NUMBER

button to input the preset code (a 5-digit
number) for

the manufacturer

of the

component whose signals you want to store in
the memory.

• The top IR segment blinks once after each button

press.

• If the remote recognizes the manufacturer’s code,

the IR segment blinks twice.

You have 10 seconds to press each digit. If it takes
longer than that, the remote “times out” and you must
begin again.

3. Tuner system buttons

•

: Tuning up/down

BAND

: Switch between AM, FM and XM bands

MODE

: Switch between AUTO and MANUAL

MEM

: Preset memory

SRCH

: RDS search

SFT

: Switch preset channel range

CH +, –

: Preset channel up/down

A ~ G

: Preset channel range

1 ~ 8

: Preset channel

NUMBER

MODE SELECTOR

RC SETUP

IR segment

• The included remote control unit (RC-1036) can be used to

operate devices of different brands by registering the preset
number corresponding to the brand of your device.

• For some models the remote control unit or the device may

not operate properly. In this case, use the learning function
(

page 85, 86) to store your device’s remote control

signals in the included remote control unit.