Echelon Mini EVK - Manual (Page 82)

Figure 5.4 NodeBuilder Debugger
You cannot simultaneously use the same network interface with both the
LonMaker tool that is included with the NodeBuilder tool and the Mini
Application. See Using the Mini Application with the LonMaker Tool later in
this chapter for information on using the LonMaker tool with the Mini
Application, or see Using the Mini Application With the NodeBuilder Tool for
more information on using the NodeBuilder tool with the Mini Application.
Using the Mini Application with LNS Applications
You can use the Mini Application with LNS applications such as the LonMaker
Integration Tool or NodeBuilder Development Tool, but you cannot have the
same network interface open in both the Mini Application and an LNS
application at the same time. To use the Mini Application with an LNS
application, you must do one of the following:
• Do not connect to the network interface in the Mini Application. You can use
an LNS network tool such as the LonMaker Integration Tool to load an
application that you compile with the Mini Application into a target device,
and test that target device.
• Use a separate network interface for the Mini Application and LNS
applications. For example, you can install two U10 USB Network Interfaces
in your computer, use one of the interfaces with the Mini Application, and
use the other with your LNS applications.
• Ensure that the Mini Application and LNS application are not attached to
the network interface at the same time. An example of this procedure is
described in the next section.
76 Mini EVK User’s Guide