Echelon Enterprise Services 2.0 - Manual (Page 34)

24 Using the i.LON AdminServer
b. The SOAP Settings dialog opens.
c. Enter the following properties:
Protocol Select the protocol used by the i.LON AdminServer to connect to the
SmartServer (HTTP or HTTPS). The selected protocol must be enabled
in the Setup - Security Web page in the SmartServer Web interface;
otherwise, the following error occurs when the i.LON AdminServer tries
to access the SmartServer: ERROR: WebService reports: "Could not
connect to i.LON SmartServer!"
• To use HTTP, the Enable Web Server check box in the Setup -
Security Web page must be selected.
• To use HTTPs, the Enable SSL Web Server check box in the Setup
- Security Web page must be selected.
Url Enter the IP address or hostname for the SmartServer to be added to the IP
channel
HTTP Port (Web
Server/SOAP) Enter the port the SmartServer uses to serve HTTP or HTTPs requests
(SOAP and WebDAV). If you are using HTTP, the default value is 80.
If you are using HTTPs, the default value is 443. You may change the
port to any valid port number. Contact your IS department to ensure your
firewall is configured to allow access to the server on this port.