Echelon i.LON 10 Ethernet Adapter - Manual (Page 65)

Message Description
received
call has been detected and answered.
PPP: Network connection
established This message indicates that a network
connection has been established through
PPP. The IP address obtained will
appear in parenthesis next to the
message.
PPP: Incoming connection
authentication succeeded
This message indicates that an incoming
call has been authenticated and a
connection has been established.
PPP: Incoming connection
authentication failed This message indicates that an incoming
call’s authentication was rejected. This
could be due to an incorrect user name or
password.
PPP: Shoulder tap rings are
received
This message indicates that the i.LON 10
has received a call with sufficient rings to
begin a shoulder tap response.
Static IP address change
detected
This message indicates that the unit
detects a static IP address change event
caused by user configuration.
Uplink session recovery event
detected This message indicates that the unit
detected a session recovery event when it
powers up or during normal operation. A
previous uplink connection was
terminated abnormally. The i.LON 10
will attempt to reconnect to the LNS
server.
Performing a Self-test
To perform a self-test on the i.LON 10, click the Perform Self-Test link on the
i.LON 10 Ethernet Adapter Web page. The i.LON 10 application halts and a self-
test procedure begins. A self-test can only be performed when the i.LON 10 is in
security access mode.
Note: The self-test procedure can cause connection problems and should not be
performed while the i.LON 10 is being used as an RNI.
The results of the test are shown in the Perform Self-test web page, shown in the
following figure:
i.LON 10 Ethernet Adapter User’s Guide 7-13