Echelon i.LON 10 Ethernet Adapter - Manual (Page 43)

your computer must be able to communicate on the 192.168.1.x subnet. This can
be accomplished in one of the following ways:
• Manually change your computer’s IP address to 192.168.1.x (where x is any
value from 2-255).
• Open a DOS command line window and enter the following command:
route add 192.168.1.0 mask 255.255.255.0
When in security access mode you can access the Security Web page and the
other features listed above until the i.LON 10 is reset.
Once you have made any changes you need to make to the Security Web page,
click Submit. The i.LON 10 will reboot and exit security access mode unless the
Allow Access to Secure Pages Without Security Access Reset (SAR) option
is set.
i.LON 10 Ethernet Adapter Security Web Page
Access the Security web page by clicking the Security link on any i.LON 10 web
page. If the Allow Access to Secure Pages Without Security Access Reset
(SAR) option is set (see below), this page is accessible even without performing a
security access reset. This page appears as shown in the following figure:
This page contains the following options:
i.LON 10 Ethernet Adapter User’s Guide 5-3