Echelon i.LON 10 Ethernet Adapter - Manual (Page 54)

i.LON 10 Diagnostics
The i.LON 10 Ethernet Adapter provides two web pages that display diagnostic
information, the Status page and the Event Log page.
Viewing i.LON 10 Ethernet Adapter Status
You can check the status of the i.LON 10 Ethernet Adapter by clicking the Status
link from the Setup web page. The Status page appears as shown in the
following figure:
This web page displays the status of the i.LON 10. This information can be used
to troubleshoot communication problems or to verify settings. All information on
this page is read-only. This page contains the following information:
System Up Time
The time since the last reset.
Load Average The load average as a percentage of the
maximum load over the last 5 seconds, 30
seconds, 5 minutes, and 30 minutes.
Firmware Version The current firmware version and the date
that firmware was built.
Neuron ID The i.LON 10 Ethernet Adapter’s 48-bit
Neuron ID expressed in hexadecimal.
Domain The L ON W ORKS Domain address of the i.LON
10 Ethernet Adapter. The length of this
7-2 i.LON 10 Ethernet Adapter Diagnostics