Echelon i.LON 10 Ethernet Adapter - Manual (Page 64)

Message Description
parenthesis in the same message. This
message may include a reason in
parenthesis, described below.
The previous three messages, may
include one of the following reasons:
(ISP_specific_message) – A message sent
by the ISP and passed on to the i.LON 10
system log. Contact your ISP for more
information on this message.
(no reply to echo requests) – PPP echo
requests do not result in a response from
the PPP peer.
(carrier lost) – The carrier has been lost.
(remote won't assign IP address) – In the
IPCP negotiation phase, the peer is not
assigning an IP address for requests from
the unit.
(xxx.xxx.xxx.xxx) – The IP address
assigned to the unit by the peer.
(could not negotiate link) – PPP could not
be established.
(could not negotiate authentication) – The
peer requests an authentication method
that is not supported and will not accept
methods the unit suggests.
(could not negotiate network) – The
network could not be negotiated.
(our standard LCP code was rejected) –
The peer rejected the standard LCP codes
that the i.LON 10 used during the LCP
negotiation.
(our standard IPCP code was rejected) –
The peer rejected the standard IPCP
codes that the i.LON 10 used during the
network negotiation.
(modem did not assert DCD) – The
modem did not send a DCD (carrier
detect) signal after being connected.
PPP: connection has been idle
for xxx seconds
This message indicates that the PPP
session has not seen any significant
packets for the amount of time shown.
This time is equal to or greater than the
configured idle timer and the connection
will be terminated.
PPP: Incoming connection is
This message indicates that an incoming
7-12 i.LON 10 Ethernet Adapter Diagnostics