Echelon NodeUtil Node Utility User Manual
Nodeutil node utility user’s guide
Table of contents
Document Outline
- Welcome
- Audience
- Related Documentation
- 1. Introduction
- 2. Using NodeUtil
- Starting NodeUtil
- The NodeUtil Main Menu
- F1 – Show Banner
- A – Add Device to List
- D – Set the Domain of the Network Interface
- E – Exit this Application
- F – Find Devices in the Current Domain
- 1 – Find Devices in All 1-Byte Domains
- G – Go to Device Menu
- H – Help with Commands
- L – Display Device List
- M – Change Device Mode or State
- P – Send a Service Pin Message
- Q – Quickly Add Device to List
- R – Reboot 3150 Device
- S – Report Device Status and Statistics
- T – Transceiver Parameters
- V – Control Verbose Modes
- W – Wink a Device
- Z – Shell Out to Command Prompt
- < – Redirect Input from a File
- > – Redirect Output to a File
- The NodeUtil Device Menu
- F1 – Show Banner
- A – Node Address Table
- B – Buffer Configuration
- C – Application Configuration Structures
- D – Device Domain Table
- E – Exit this Menu and Return to Main Menu
- F – Configuration Files
- G – Go to Another Device
- H – Help with Device Commands
- I – Network Variable Alias Table
- J – Jam Network Variable Type
- K – Check Neuron Executable
- L – List Network Variables
- M – Change Device Mode or State
- N – Network Variable Configuration Table
- P – Poll Network Variable
- Q – Quickly Send a Message
- R – Read Device Memory
- S – Report Device Status and Statistics
- T – Transceiver Parameters
- U – Update Input Network Variable
- V – Control Verbose Modes
- W – Write Device Memory
- X – Create Device Interface (XIF) File
- Y – Download Neuron Executable
- [ – Performance Test
- = – Signal Strength
- * – Refresh Memory
- < – Redirect Input from a File
- > – Redirect Output to a File
- Using a Script File with NodeUtil
- A. License Agreement