Echelon i.LON 10 Ethernet Adapter - Manual (Page 14)

supply should be used with the power-line
model.
10Base-T Ethernet Port Standard 10BaseT connection, type RJ-45.
L ON W ORKS TP/FT-10 Port For the free-topology model, an orange
Weidmuller connector (Weidmuller model
#134686) connected to an Echelon TP/FT-10
transceiver. This port exists only on the free-
topology model.
Serial Port A DB-9 serial port. Can be used to connect
the i.LON 10 Ethernet adapter to a modem.
See i.LON 10 Serial Port Pinout, below, for
more information about this port.
Service Pin Service pin is a recessed pushbutton used to
send a L
ON W ORKS service pin message on the
L ON W ORKS channel. This button is also used
to perform a security access reset as described
in Security Access Reset.
i.LON 10 Serial Port Pinout
When connecting a DCE modem with a DB-9 serial port to the i.LON 10, the
signals are communicated as shown in Table 2-1.
Table 2-1
DCE Modem to DTE i.LON 10 Adapter Connection (DB-9 to DB-9)
Modem Signal
Name Cable DB-9
Male Cable DB9
Female i.LON 10 (DTE)
DB-9 Male
DCD Pin 1 Pin 1 DCD—Pin 1
RxD Pin 3 Pin 3 RxD—Pin 2
TxD Pin 2 Pin 2 TxD—Pin 3
DTR Pin 4 Pin 4 DTR—Pin4
GND Pin 5 Pin 5 GND—Pin 5
DSR Pin 6 Pin 6 DSR—Pin 6
RTS Pin 7 Pin 7 RTS—Pin 7
CTS Pin 8 Pin 8 CTS—Pin 8
When connecting a DTE modem with requiring a null modem cable with a DB-9
serial port to an i.LON 10, the signals are communicated as shown in Table 2-2.
2-4 i.LON 10 Ethernet Hardware