Echelon i.LON 10 Ethernet Adapter User Manual
Page 59
Message Description
Port #n: could not write
Configuration data after
xDriver INCAUTH command
This message indicates that the new
secret key and configuration were not
properly saved. This message should
never be seen. If it is, the unit should
probably be returned for service (ie, a new
flash chip installed.)
Port #n: Listening for
connection on tcp port
The i.LON 10 Ethernet Adapter is setting
up a socket to listen for LNS Servers on
the given port number.
Port #n: Connection attempt
to ###.###.###.###:#####..."
This message indicates that the system
has started the process to contact the
remote LNS server at the given IP
address given on port number.
Port #n: Incoming connection
on tcp port xxxx from
###.###.###.###:#####
The i.LON 10 Ethernet Adapter has
detected an incoming communication
from a remote host.
Port #n: Keep alive timeout
detected on LNS connection
This message indicates that the
connection to the LNS server is non-
responsive. A keep-alive message was
sent with no response from the LNS
server.
Port #n: Connection was
established with
###.###.###.###:#####
The i.LON 10 Ethernet Adapter detected
an incoming communication and a
connection has been established.
Port #n: Connection was
refused by
###.###.###.###:#####…
The i.LON 10 Ethernet Adapter would
not accept a connection.
Port #n: No response
connecting to host at
###.###.###.###:#####
This message indicates that the remote
system has not responded to any TCP
session establishment requests.
Port #n: No response from
host at ###.###.###.###:#####
This message indicates that the remote
system has stopped responding to TCP
traffic we are sending after it had been
responding earlier.
Port #n: Connection reset by
remote host at
###.###.###.###:#####
This message indicates that the remote
host forcibly terminated the TCP session
that was started or active.
Port #n: Connection closed by
us to host at
###.###.###.###:#####
This message indicates that the TCP
session is being closed by the i.LON 10.
Port #n: Connection closed by
remote host at
###.###.###.###:#####
This message indicates that the remote
host has requested a close of TCP
communications.
i.LON 10 Ethernet Adapter User’s Guide
7-7