Sears 385. 19601 - Manual (Page 17)

SECTION 2. PREPARE YOUR MACHINE FOB SEWING
o Check Your Presser Foot
Your presssf toot is held m place by a Foot Holder. Each presser loot
merely snaps on the toot holder, which is seldom removed.
If you need to femoye or attach the tool holder, here is whai you do;
To Remove; To Attach:
Turn the screw toward the back of
the machine. Use the large screw
driver.
Match the hole in the toot
holder with ihe threaded hole
m the presser bar.
Fit the tool holder screw mto
the bole.
Tighten the screw by turning ii
toward you.
« Change the Pressor Foot
Use the correct presser toot tor the stitch you wish to sew. Consult the Stitch Pailern
Chart and the detailed direciions tor sewmg with the various presser feet.
To snap off: To snap on:
Press the Up/Down Needle Position Button
to raise the needle to its highest position.
Raise the presser loot.
Press the red buuon on the back ol the toot
holder. The presser loot will drop off.
Foot:
Set the Pressure Dial at
2. Place the presser tool
50 the horizontal pm on
the loot lies iiist under
the groove of the toot
holder.
3. Lower the presser loot
holder to lock the
presser toot in place.
NOTE; If you do not hear the presser loot snap m place, press down on the presser
loot holder firmly until you hear the snap.
15