Zipper sewing (continued) – Sears 385.12912 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Zipper Sewing (Continued)
° To sew:
® Zipper teeth
(D Zipper tape
d) Wrong side (Bottom side) of fabric
m Fold back the left seam allowance. Turn under the right
seam allowance to form a 0 2 to 0 3 cm (1/8'') fold
Place the zipper teeth ©next to this fold and pin in place
[|] To sew the left side of the zipper, set the zipper foot on
the left side of the needle Lower the zipper foot on the
top side at the bottom of the zipper so that the needle
pierces the fabric next to the fold and the zipper tape©.
Sew through ail layers next to the fold. Stop just before
the zipper foot reaches the slider on the zipper tape
about 5 cm (2") from the top of the zipper. Lower the
needle slightly into the fabric, raise the foot and remove
the basting stitches along the zipper opening
3
)
Slider
(5) Right side (Top side) of fabric
Open the zipper to move the siiderCD behind
the zipper foot
Lower the foot and stitch the remainder of the
seam, making sure the fold is even
E
Close the zipper and spread the fabric flat with
the right side (top side) of fabric(|) facing up
[|] Set the zipper foot on the right side of the needle
Guide the edge of the foot along the zipper teeth
© and stitch through the garment and zipper
tape.
I Stop at about 5 cm (2") from the top of the zipper
Lower the needle slightly into the fabric, raise the
foot
Open the zipper to move the slider ©behind the
zipper foot
Lower the foot and stitch the remainder of the
seam, making sure the fold is even
36