Sears 385.12912 - Manual (Page 32)

Threading the Machine
* Threading the machine
* Raise the thread take-up lever to its highest position
by turning the handwheel counterclockwise, toward
you.
* Raise the presser foot lifter,
* Place a spool on the spool pin, with thread coming
off as shown.
¡n Draw the end of thread around the upper thread guide.
[2] White holding the thread near the spool, draw the
end of the thread down around the check spring
holder
m Firmly draw the thread up from right to left over
the take-up lever and down Into the take-up lever
eye,
(Tj Slide the thread behind the needle bar thread
guide on the left
[U Thread the needle from front to back or use a
needle threader.
We recommend using the convenient needle
threader (#200262101), included with your
machine.
» Drawing up bobbin thread
m Raise the presser foot Hold the needle thread
lightly with your left hand and rotate the handwheel
counterclockwise, toward you, for one complete turn.
m Bring the bobbin thread up by pulling the needle
thread up.
I Pull both threads under and to the back of the
presser foot, toying 10 cm to 15 cm (4 to 6 inches)
of thread clear.
24