Carrier Access CMG Router User Manual
Page 48
3-10
CMG Router - Release 2.7
Profile Directory:Router Card Profile
Security
Authentication of Remote
Protocol: CHAP, PAP or NONE
Use this field to identify the authentication protocol to be used by this Adit unit when authenticating
remote devices.
Local Security Server
Use these fields to identify the local server that is used to authenticate remote devices. This field
is only necessary if you are using either the
authentication method. If you are not using either of these security methods, the Adit unit will
respond to the authentication requests of remote devices and will accept or reject them based on
their validity.
Type
Use the
[S
PACEBAR
]
to choose the security authentication method that you are using.
<None> Use this setting if the local Adit unit will be used to authenticate remote devices. Please
note that you may not use the <None> setting if the Security Server field for a remote device has
been set to <External Server>
<RADIUS>
Will set the server to use the RADIUS (Remote Authentication Dial-In Service)
protocol. RADIUS is a client/server-based authentication software system.
<TACACS+>
Will set the server to use the TACACS+ (Terminal Access Controller Access
Control System) protocol. TACACS+ provides services of authentication, authorization
and accounting independently.
Address
Enter the IP Address of the local server that will be used during the authentication process. If
Password
Enter the password of the local server that will be used during the authentication process. You must
make sure that the password entered into the server is the same as the value entered here or the
authentication process will fail. If
disabled.