Carrier Access CMG Router - Manual (Page 16)

1-2 CMG Router - Release 2.7
Introduction
Overview
Overview
This manual covers the Router menu-driven user interface only, all other information
for the Router can be found in the Adit 600 User Manual.
The Router can be configured using CLI via telnet, through the Router Menu-driven
software.
The CMG Router has the following versions:
CMG Service card
CMG-01 Service card
CMG-02 Service card
CMG/CMG-02 Service card with G.729
Windows displaying the G.729 feature will be clearly noted in this manual.
Installation
The Router card can be installed into any of the service card slots (1-6) of the Adit 600
chassis. This card is hot-swappable, therefore the card can be removed and replaced
without bringing down the system or with or without power to the unit.
Install a Router Card
1. Slide the Router card into a service card slot of the chassis.
2. Press firmly into slot to engage, until card is seated completely.
3. Card has completed bootup when a solid Red CRD light (an LED) is displayed.
Install Country Specific Ringer Tones
The CMG Router card ships with a set of call progress tone files that allow call progress
tone definitions for a number of other countries to be used.The tones are played to a
VoIP endpoint at the direction of an external MGCP call agent. By default the call
progress are defined to match the United States standard call progress tones.
Tones are loaded via TFTP directly to the CMG Router card. All supported country
tones are provided on the software CD with the CMG Router. For more information see
the Adit 600 User Manual.