Candle KLVHSKONCT GC32-9172-00 User Manual
Page 442
442
Candle Products Messages Manual (KLVHS–KONCT)
KO4SRV068
Input not supplied for required fields.
Explanation: A required parameter was not specified.
User Response: Enter the correct value for highlighted fields.
Severity: 30
System Programmer Response:No
KO4SRV069
Situation definition &1 not found.
Explanation: The Candle Management Server (CMS) could not locate situation
definition
&1
.
User Response: If the definition contains mixed case characters, enclose the
definition in single quotes. Check that situation
&1
is spelled correctly.
Severity: 10
System Programmer Response:No
KO4SRV070
Configuration information changed.
Explanation: The CONFIGURE CMS command was used to change
configuration options.
User Response: View current configuration options. End the Candle
Management Server (CMS) and then start it again to run with new options.
Severity: 0
System Programmer Response:No
KO4SRV071
Data not valid for this field.
Explanation: The Candle Management Server (CMS) detected incorrect data
for a specific field. For example, a field that requires numeric data contains
character data.
User Response: Verify that you are using the kind of data required for this
field.
Severity: 30
System Programmer Response:No
KO4SRV072
Not able to read record in configuration file.
Explanation: The Candle Management Server (CMS) encountered error
condition
&1
, message ID
&2
while reading keyed record
&3
in file
&4
. Either the
key length is incorrect or an I/O error occurred. The configuration file is not read.
User Response: Check the file for errors and try the configuration command
again.
Severity: 30
System Programmer Response:Unattended
KO4SRV073
Not able to locate record in configuration file.
Explanation: The Candle Management Server (CMS) encountered error
condition &1, error ID
&2
while locating keyed record
&3
in file
&4
. Either the file
was not opened for read operations or an I/O error occurred. The configuration
file was not read.
User Response: Check the configuration file for errors and try the command
again.
Severity: 30
System Programmer Response:Unattended