beautypg.com

Candle KLVHSKONCT GC32-9172-00 User Manual

Page 356

background image

356

Candle Products Messages Manual (KLVHS–KONCT)

KN3CV136

VALID RANGE IS 10–3600

Explanation: The automatic screen refresh interval must be in the range of 10–
3600 seconds.
System Action: None.
User Response: Specify a number that is not less than 10 and is not greater
than 3600.
Message Type:

User input error.

KN3CV137

THE CONTROL BLOCK CANNOT BE ACCESSED FOR ONE OF THE
FOLLOWING REASONS:

1. THE CONTROL BLOCK IS NO LONGER VALID.

2. AN ATTEMPT TO ACCESS THE ADDRESS SPACE FAILED

Explanation: The control block is not available for display because the control
block address is no longer valid, or an attempt to swap in the address space failed.
System Action: None.
User Response: Press Enter to continue.
Message Type:

Information.

KN3CV138

THE ADDRESS SPACE HAS TERMINATED

Explanation: The control block data is not available for display because the
address space is gone.
System Action: None.
User Response: Press Enter to continue.
Message Type:

Information.

KN3CV139

THE ADDRESS SPACE IS BEING SWAPPED IN, TRY AGAIN LATER

Explanation: The control block data is not available for display because the
address space is being swapped in.
System Action: None.
User Response: Press Enter to continue. Try to access the data at a later time,
after the address space has been swapped in.
Message Type:

Information.

KN3CV140

THERE WAS NO RPL CONTROL BLOCK FOUND FOR THIS SESSION

Explanation: Due to the transient nature of control blocks, an RPL with a CID
matching this session's CID could not be found. The data cannot be displayed.
System Action: None.
User Response: Press Enter to continue.
Message Type:

Information.

KN3CV141

UNABLE TO DISPLAY THE CONTROL BLOCK DATA. CHECK THE
MESSAGE LOG FOR MORE INFORMATION

Explanation: An error occurred while trying to display the requested data
System Action: None.
User Response: Press Enter to continue. Note the OMEGAMON II collector's
return and sense codes, on the message log or OMEGAMON II's SYSOUT, and
report them to Candle Support Services.
Message Type:

Internal error.